Displaying Mpls Oam - HP HPE FlexNetwork MSR Router Series Configuration Manual

Step
4. Use BFD to verify PW
connectivity.
5. Specify the VCCV CC type.
6. Return to system view.
7. Enter VSI view.
8. Configure the VSI to
establish PWs using LDP
and enter VSI LDP view.
9. Configure a VPLS PW,
specify the created PW
class for it, and enter VSI
LDP PW view.
10. (Optional.) Set the local and
remote discriminators for
the BFD session used to
verify PW connectivity.
11. (Optional.) Configure an
LDP backup PW, specify
the PW class for the backup
PW, and enter VSI LDP
backup PW view.
12. (Optional.) Set the local and
remote discriminators for
the BFD session used to
verify the connectivity of the
backup PW.

Displaying MPLS OAM

Execute display commands in any view.
Task
Display BFD information for LSP
tunnels or MPLS TE tunnels.
Display BFD information for PWs.
Command
vccv bfd [ raw-bfd ] [ template
template-name ]
vccv cc { control-word |
router-alert }
quit
vsi vsi-name [ hub-spoke ]
pwsignaling ldp
peer ip-address pw-id pw-id
pw-class class-name [ hub |
no-split-horizon | tnl-policy
tunnel-policy-name ] *
bfd discriminator local local-id
remote remote-id
backup-peer ip-address pw-id
pw-id pw-class class-name
[ tunnel-policy
tunnel-policy-name ]
bfd discriminator local local-id
remote remote-id
Command
display mpls bfd [ ipv4 dest-addr mask-length | te tunnel
tunnel-number ]
display l2vpn pw bfd [ peer peer-ip pw-id pw-id ]
521
Remarks
a PW, you must create a PW class
for the PW and configure VCCV
settings in PW class view.
By default, BFD is not used to verify
PW connectivity.
If you specify the raw-bfd keyword
in this command, make sure you
specify the VCCV CC type as
control-word.
By default, no VCCV CC type is
specified.
N/A
N/A
N/A
By default, no VPLS PW is
configured.
By default, no local and remote
discriminators are set.
Make sure the local discriminator
and remote discriminator
configured on the local PE are the
same as the remote discriminator
and local discriminator configured
on the remote PE, respectively.
By default, no backup VPLS PW is
configured.
By default, no local and remote
discriminators are set.
Make sure the local discriminator
and remote discriminator
configured on the local PE are the
same as the remote discriminator
and local discriminator configured
on the remote PE, respectively.