Ipv6 Ldp Configuration Examples; Ipv6 Ldp Lsp Configuration Example - HP HPE FlexNetwork MSR Router Series Configuration Manual

[RouterA-GigabitEthernet2/0/1] mpls enable
[RouterA-GigabitEthernet2/0/1] mpls ldp enable
[RouterA-GigabitEthernet2/0/1] quit
[RouterA] interface gigabitethernet 2/0/2
[RouterA-GigabitEthernet2/0/2] mpls enable
[RouterA-GigabitEthernet2/0/2] mpls ldp enable
[RouterA-GigabitEthernet2/0/2] quit
5. Configure IPv4 LSP generation policies so LDP uses all static routes and IGP routes to
establish LSPs:
# Configure Router S.
[RouterS] mpls ldp
[RouterS-ldp] lsp-trigger all
[RouterS-ldp] quit
# Configure Router D.
[RouterD] mpls ldp
[RouterD-ldp] lsp-trigger all
[RouterD-ldp] quit
# Configure Router A.
[RouterA] mpls ldp
[RouterA-ldp] lsp-trigger all
[RouterA-ldp] quit
Verifying the configuration
# Verify that primary and backup LSPs have been established.
[RouterS] display mpls ldp lsp 21.1.1.0 24
Status Flags: * - stale, L - liberal, B - backup
FECs: 1
FEC
21.1.1.0/24

IPv6 LDP configuration examples

IPv6 LDP LSP configuration example

Network requirements
Router A, Router B, and Router C all support MPLS.
Configure LDP to establish IPv6 LSPs between Router A and Router C, so subnets 11::0/64 and
21::0/64 can reach each other over MPLS.
Configure LDP to establish LSPs only for destinations 100::1/128, 100::2/128, 100::3/128, 11::0/64,
and 21::0/64 on Router A, Router B, and Router C.
Ingress: 2
In/Out Label
-/1276
2174/1276
-/1276(B)
2174/1276(B)
55
Transit: 2 Egress: 0
Nexthop OutInterface
13.13.13.2 GE2/0/2
13.13.13.2 GE2/0/2
12.12.12.2 GE2/0/1
12.12.12.2 GE2/0/1