Configuring Mpls Tracert For Lsps - HP HPE FlexNetwork MSR Router Series Configuration Manual

Task

Configuring MPLS tracert for LSPs

Perform the following task in any view:
Task
Use MPLS tracert to trace the LSPs for
an IPv4 prefix.
Configuring BFD for LSPs
To configure BFD for an LSP, configure both the local and remote devices as described in
Table 48 Configurations on the local and remote devices
BFD session
establishment
mode
Static mode
Dynamic mode
Follow these guidelines to configure BFD for an LSP tunnel:
•
To establish a static BFD session, ensure that the local and remote discriminators configured
locally are identical with the remote and local discriminators configured on the remote device,
respectively.
•
The source address of the BFD session is the MPLS LSR ID of the local device. Before
configuring BFD for the LSP tunnel, perform the following tasks:
a. Configure an MPLS LSR ID for the local device.
b. Make sure a route is available on the remote device to reach the MPLS LSR ID.
•
If multiple LSPs exist for an FEC, you can perform one of the following tasks:
Create a BFD session for an LSP by specifying the next hop of the LSP.
This configuration is not available for nested LSP connectivity verification.
Create a BFD session for each LSP without specifying a next hop.
•
On a BFD session established in static mode, the ingress node and egress node both operate
in active mode. On a BFD session established in dynamic mode, the egress node operates in
active mode and the ingress node operates in passive mode. Executing the bfd session
init-mode command on the ingress or egress node does not change the node's operating
mode.
To configure BFD for LSPs:
Command
tracert mpls [ -a source-ip | -exp exp-value | -h ttl-value | -r
reply-mode | -rtos tos-value | -t time-out | -v | fec-check ] * ipv4
dest-addr mask-length [ destination start-address [ end-address
[ address-increment ] ] ]
Execute the "mpls
Node type bfd enable"
command?
Local Yes
Remote Yes
Local Yes
Remote Yes
Command
[ address-increment ] ] ]
Execute the
"mpls bfd"
command?
Yes
Yes
Yes
No
515
Table 48.
Configure the
discriminator
keyword?
Yes
Yes
No
N/A