HP HPE FlexNetwork MSR Router Series Configuration Manual page 362

Step
2. Configure an IPv6
static route for an IPv6
VPN instance.
3. (Optional.) Configure
the default preference
for IPv6 static routes.
Configuring RIPng between an MCE and a PE
Step
1. Enter system view.
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
3. Redistribute VPN routes.
4. (Optional.) Configure the
default cost value for
redistributed routes.
5. Return to system view.
6. Enter interface view.
7. Enable the RIPng process on
the interface.
Configuring OSPFv3 between an MCE and a PE
Step
1. Enter system view.
2. Create an OSPFv3 process
for an IPv6 VPN instance
and enter OSPFv3 view.
3. Set the router ID.
4. Disable routing loop
detection.
5. (Optional.) Configure an
OSPFv3 domain ID.
Command
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost | route-policy
route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
router-id router-id
vpn-instance-capability simple
domain-id { domain-id
[ secondary ] | null }
352
Remarks
By default, no IPv6 static
route is configured.
The default value is 60.
Remarks
N/A
N/A
By default, no routes are
redistributed into RIPng.
The default value is 0.
N/A
N/A
By default, RIPng is disabled
on an interface.
Remarks
N/A
N/A
N/A
By default, routing loop detection
is enabled.
On an MCE network, you must
disable routing loop detection for
a VPN OSPFv3 process.
Otherwise, the MCE does not
receive OSPFv3 routes from the
PE.
The default domain ID is 0.