Establishing An Mpls Te Tunnel With Rsvp-Te - HP HPE FlexNetwork MSR Router Series Configuration Manual

FEC
1.1.1.1/0/1
2.1.1.2
Tunnel0
[RouterB] display mpls lsp
FEC
-
3.2.1.2
[RouterC] display mpls lsp
FEC
-
[RouterA] display mpls static-cr-lsp
Name
static-cr-lsp-1 Ingress
[RouterB] display mpls static-cr-lsp
Name
static-cr-lsp-1 Transit
[RouterC] display mpls static-cr-lsp
Name
static-cr-lsp-1 Egress
# Execute the display ip routing-table command on Router A. The output shows a static route entry
with interface Tunnel 0 as the output interface. (Details not shown.)

Establishing an MPLS TE tunnel with RSVP-TE

Network requirements
Router A, Router B, Router C, and Router D run IS-IS and all of them are Level-2 routers.
Use RSVP-TE to create an MPLS TE tunnel from Router A to Router D. The MPLS TE tunnel
requires a bandwidth of 2000 kbps.
The maximum bandwidth of the link that the tunnel traverses is 10000 kbps and the maximum
reservable bandwidth of the link is 5000 kbps.
Figure 33 Network diagram
Table 3 Interface and IP address assignment
Device
Router A
Proto
StaticCR -/20
Local
Local
Proto
StaticCR 20/30
Local
Proto
StaticCR 30/-
LSR Type In/Out Label
Null/20
LSR Type In/Out Label
20/30
LSR Type In/Out Label
30/Null
Interface IP address
Loop0 1.1.1.9/32
In/Out Label Interface/Out NHLFE
GE2/0/1
-/- GE2/0/1
-/- NHLFE1025
In/Out Label Interface/Out NHLFE
GE2/0/2
-/- GE2/0/2
In/Out Label Interface/Out NHLFE
-
Out Interface
GE2/0/1
Out Interface
GE2/0/2
Out Interface
-
Device Interface
Router C Loop0
111
State
Up
State
Up
State
Up
IP address
3.3.3.9/32