Protocols And Standards; Rsvp Configuration Task List; Enabling Rsvp; Configuring Rsvp Refresh - HP HPE FlexNetwork MSR Router Series Configuration Manual

Protocols and standards

•
RFC 2205, Resource ReSerVation Protocol
•
RFC 3209, RSVP-TE: Extensions to RSVP for LSP Tunnels
•
RFC 2961, RSVP Refresh Overhead Reduction Extensions

RSVP configuration task list

Tasks at a glance
(Required.)
(Optional.) Perform the following tasks on each node of an MPLS TE tunnel according to your network
requirements:
•

Configuring RSVP refresh

•
Configuring RSVP Srefresh and reliable RSVP message delivery
•
Configuring RSVP hello extension
•
Configuring RSVP authentication
•
Setting a DSCP value for outgoing RSVP packets
•
Configuring RSVP GR
•
Enabling BFD for RSVP

Enabling RSVP

Step
1. Enter system view.
2. Enable global RSVP and enter
RSVP view.
3. Return to system view.
4. Enter interface view.
5. Enable RSVP on the interface.
Configuring RSVP refresh
Step
1. Enter system view.
2. Enter RSVP view.
3. Set the refresh interval for
Path and Resv messages.
4. Set the PSB and RSB
timeout multiplier.
Enabling RSVP
Command
system-view
rsvp
quit
interface interface-type
interface-number
rsvp enable
Command
system-view
rsvp
refresh interval interval
keep-multiplier number
168
Remarks
N/A
By default, global RSVP is
disabled.
N/A
N/A
By default, RSVP is disabled
on the interface.
Remarks
N/A
N/A
By default, the refresh interval is
30 seconds for both path and
Resv messages.
By default, the PSB and RSB
timeout multiplier is 3.