Configuring Bgp As Number Substitution - HP HPE FlexNetwork MSR Router Series Configuration Manual

Destination: 2012:1::/64
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
# Verify that PE 1 has learned the private route of VPN 2 through OSPFv3.
[PE1] display ipv6 routing-table vpn-instance vpn2
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop
Interface
Destination: 2002:2::/64
NextHop
Interface
Destination: 2002:2::4/128
NextHop
Interface
Destination: 2012::/64
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
The routing information for the two VPNs has been redistributed into the routing table on PE 1.

Configuring BGP AS number substitution

Network requirements
As shown in
two CEs have the same AS number, 600. Configure BGP AS number substitution on the PEs to
avoid route loss.
: FE80::200:5EFF:FE01:1C05
: GE2/0/1.1
: ::
: NULL0
: ::
: NULL0
: ::1
: InLoop0
: ::
: GE2/0/1.2
: ::1
: InLoop0
: FE80::200:5EFF:FE01:1C06
: GE2/0/1.2
: ::
: NULL0
: ::
: NULL0
Figure 98, CE 1 and CE 2 belong to VPN 1, and are connected to PE 1 and PE 2. The
396
Protocol : O_ASE2
Preference: 15
Cost : 10
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : O_ASE2
Preference: 15
Cost : 10
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0