Configuring Routing Between A Pe And A Ce - HP HPE FlexNetwork MSR Router Series Configuration Manual

Step
7. Apply a tunnel policy to the
VPN instance.

Configuring routing between a PE and a CE

You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, EBGP, or IBGP between a PE and
a CE.
Configuring IPv6 static routing between a PE and a CE
Step
1. Enter system view.
2. Configure an IPv6 static
route for a VPN
instance.
Configuring RIPng between a PE and a CE
A RIPng process belongs to the public network or a single VPN instance. If you create a RIPng
process without binding it to a VPN instance, the process belongs to the public network.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between a PE and a CE:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter
RIPng view.
3. Return to system view.
4. Enter interface view.
5. Enable RIPng on the
interface.
Command
tnl-policy tunnel-policy-name
Command
system-view
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address
[ public ] | vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
quit
interface interface-type
interface-number
ripng process-id enable
335
Remarks
By default, only one tunnel is
selected (no load balancing) in
this order: LSP tunnel, GRE
tunnel, and CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."
Remarks
N/A
By default, no IPv6 static
route is configured for a
VPN instance.
Perform this
configuration on the PE.
On the CE, configure a
common IPv6 static
route.
For more information
about IPv6 static routing,
see Layer 3—IP Routing
Configuration Guide.
Remarks
N/A
Perform this configuration on the
PE. On the CE, create a common
RIPng process.
N/A
N/A
By default, RIPng is disabled on
an interface.