HP HPE FlexNetwork MSR Router Series Configuration Manual page 262

Device
Spoke-PE 2
Configuration procedure
1. Configure an IGP on the MPLS backbone to ensure IP connectivity within the backbone:
# Configure Spoke-PE 1.
<Spoke-PE1> system-view
[Spoke-PE1] interface loopback 0
[Spoke-PE1-LoopBack0] ip address 1.1.1.9 32
[Spoke-PE1-LoopBack0] quit
[Spoke-PE1] interface pos 2/2/0
[Spoke-PE1-Pos2/2/0] ip address 172.1.1.1 24
[Spoke-PE1-Pos2/2/0] quit
[Spoke-PE1] ospf
[Spoke-PE1-ospf-1] area 0
[Spoke-PE1-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255
[Spoke-PE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[Spoke-PE1-ospf-1-area-0.0.0.0] quit
[Spoke-PE1-ospf-1] quit
# Configure Spoke-PE 2.
<Spoke-PE2> system-view
[Spoke-PE2] interface loopback 0
[Spoke-PE2-LoopBack0] ip address 3.3.3.9 32
[Spoke-PE2-LoopBack0] quit
[Spoke-PE2] interface pos 2/2/0
[Spoke-PE2-Pos2/2/0] ip address 172.2.1.1 24
[Spoke-PE2-Pos2/2/0] quit
[Spoke-PE2] ospf
[Spoke-PE2-ospf-1] area 0
[Spoke-PE2-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255
[Spoke-PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[Spoke-PE2-ospf-1-area-0.0.0.0] quit
[Spoke-PE2-ospf-1] quit
# Configure Hub-PE.
<Hub-PE> system-view
[Hub-PE] interface loopback 0
[Hub-PE-LoopBack0] ip address 2.2.2.9 32
[Hub-PE-LoopBack0] quit
[Hub-PE] interface pos 2/2/0
[Hub-PE-Pos2/2/0] ip address 172.1.1.2 24
[Hub-PE-Pos2/2/0] quit
[Hub-PE] interface pos 2/2/1
[Hub-PE-Pos2/2/1] ip address 172.2.1.2 24
[Hub-PE-Pos2/2/1] quit
[Hub-PE] ospf
Interface IP address
Loop0 3.3.3.9/32
GE2/0/1 10.2.1.2/24
POS2/2/0 172.2.1.1/24
Device Interface
GE2/0/1
GE2/0/2
252
IP address
10.3.1.2/24
10.4.1.2/24