Table of Contents
Advertisement
Configuring MPLS QoS
The MPLS-related knowledge is necessary for understanding MPLS QoS. For more information
about MPLS, see MPLS Configuration Guide. For more information about EXP precedence, see
"Configuring priority mapping." For more information about traffic policing, see "Configuring traffic
policing, traffic shaping, and line rate." For more information about priority marking, see "Configuring
priority marking." For more information about congestion management, see "Configuring congestion
management."
Overview
In the area of QoS, to provide the support for DiffServ as IP does, MPLS uses 3 bits analogous to IP
precedence, called "EXP bits," to carry class-of-service information. With the EXP bits, MPLS QoS is
achieved to identify different traffic flows and implement differentiated services, guaranteeing low
delay and low packet loss ratio for voice and video traffic.
MPLS QoS supports Committed Access Rate (CAR), priority marking, and congestion management.
MPLS QoS provides the following functions:
•
Classify traffic on the PE to apply differentiated QoS strategies for different traffic classes. For
example, MPLS QoS can organize packets with EXP value 1 into a class and packets with EXP
value 2 into another class, and then perform traffic policing and priority marking for each class
of packets.
•
When a PE labels a packet, it maps the IP precedence to the EXP field of the label. In this way,
the class information carried in the IP header is carried in the label.
•
Differentiated dispatching (such as PQ, WFQ, or CBQ) is performed between a P device and a
PE according to the EXP field to provide differentiated QoS for labeled traffic on an LSP.
The EXP field in an MPLS label is processed following these rules:
•
Any QoS-capable device can reset the EXP field of the topmost label.
•
During label encapsulation, the ToS field of the IP packet is directly changed into the EXP field
of the MPLS label.
•
The EXP field remains unchanged when label swapping is performed.
•
During a label push operation, the EXP field of the newly pushed outer label inherits the EXP
field of the inner label.
•
After a label pop operation, if the packet is still an MPLS packet, the EXP field of the popped
label is not copied to the inner label; if the packet is an IP packet, the EXP field of the popped
label is not copied to the ToS field of the IP packet.
Configuring MPLS CAR
By configuring CAR for traffic entering an MPLS network, you can limit the transmission rate to avoid
network congestion, and in addition, mark priority for the traffic.
Before you configure MPLS CAR, complete basic MPLS configurations. For more information about
basic MPLS configurations, see MPLS Configuration Guide.
To configure MPLS CAR:
Step
1.
Enter system view.
Command
system-view
119
Advertisement
Table of Contents
