Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Configure an IPv6
static route for an IPv6
VPN instance.
3.
(Optional.) Configure
the default preference
for IPv6 static routes.
Configuring RIPng between an MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
VPNs to be exchanged between the MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Step
1.
Enter system view.
2.
Create a RIPng process for a
VPN instance and enter
RIPng view.
3.
Redistribute remote site
routes advertised by the PE.
4.
(Optional.) Configure the
default cost value for the
redistributed routes.
5.
Return to system view.
6.
Enter interface view.
7.
Enable RIPng on the
interface.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public
network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of
different IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
Command
system-view
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ] |
vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol
[ process-id ] [ allow-ibgp ]
[ allow-direct | cost cost |
route-policy route-policy-name ]
*
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
347
Remarks
N/A
By default, no IPv6
static route is
configured.
Perform this
configuration on the
MCE. On a VPN site,
configure normal IPv6
static routes.
The default
preference for IPv6
static routes is 60.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no routes are
redistributed into RIPng.
The default value is 0.
N/A
N/A
RIPng is disabled by default.
Advertisement
Table of Contents
