Protocols; Compatibility Information; Ldp Configuration Task List - HP HPE FlexNetwork MSR Router Series Configuration Manual

carried on the MPLS TE LSP, creating a hierarchical LSP. For more information about MPLS TE
tunnels, see

Protocols

•
RFC 5036, LDP Specification
•
draft-ietf-mpls-ldp-ipv6-09.txt

Compatibility information

Commands and descriptions for centralized devices apply to the following routers:
•
MSR1002-4/1003-8S.
•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

LDP configuration task list

Tasks at a glance
Enable LDP:
1. (Required.)
2. (Required.)
(Optional.) Configuring Hello parameters
(Optional.) Configuring LDP session parameters
(Optional.) Configuring LDP backoff
(Optional.) Configuring LDP MD5 authentication
(Optional.) Configuring LDP to redistribute BGP unicast routes
(Optional.) Configuring an LSP generation policy
(Optional.) Configuring the LDP label distribution control mode
(Optional.) Configuring a label advertisement policy
(Optional.) Configuring a label acceptance policy
(Optional.) Configuring LDP loop detection
(Optional.) Configuring LDP session protection
(Optional.) Configuring LDP GR
(Optional.) Configuring LDP NSR
(Optional.) Configuring LDP-IGP synchronization
(Optional.) Configuring LDP FRR
(Optional.) Setting a DSCP value for outgoing LDP packets
(Optional.) Resetting LDP sessions
(Optional.) Enabling SNMP notifications for LDP
"Configuring MPLS TE."
Enabling LDP globally
Enabling LDP on an interface
25