Configuring Routing Between A Pe And A Ce - HP HPE FlexNetwork MSR Router Series Configuration Manual

Configuring route related attributes for a VPN instance
Step
1. Enter system view.
2. Enter VPN instance
view or IPv4 VPN view
3. Configure route targets.
4. Set the maximum
number of active routes
allowed.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to
the VPN instance.

Configuring routing between a PE and a CE

You can configure static routing, RIP, OSPF, IS-IS, EBGP, or IBGP between a PE and a CE.
Command
system-view
•
Enter VPN instance view:
ip vpn-instance
vpn-instance-name
•
Enter IPv4 VPN view:
a. ip vpn-instance
vpn-instance-name
b. address-family ipv4
vpn-target vpn-target&<1-8> [ both |
export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
213
Remarks
N/A
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv4 VPN prefers the
configurations in IPv4 VPN view
over the configurations in VPN
instance view.
By default, no route targets are
configured.
The default varies by device
model. For the default values, see
MPLS Command Reference.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing) in
this order: LSP tunnel, GRE
tunnel, and CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."