Table of Contents
Advertisement
Step
3.
Enter cross-connect view.
4.
Configure a static PW, and
enter cross-connect PW
view.
5.
Configure the expected
bandwidth of the PW.
Configuring an LDP PW
Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information
about MPLS LDP configuration, see
To configure an LDP PW:
Step
1.
Enter system view.
2.
Enter cross-connect group
view.
3.
Enter cross-connect view.
4.
Configure an LDP PW, and
enter cross-connect PW
view.
5.
Configure the expected
bandwidth for the PW.
Configuring a BGP PW
To configure a BGP PW, perform the following configurations on PEs:
•
Configure BGP to advertise MPLS L2VPN label block information.
•
Create a BGP PW.
Configuring BGP to advertise MPLS L2VPN label block information
Step
1.
Enter system view.
2.
Enable BGP and enter BGP
view.
3.
Configure the remote PE as a
BGP peer.
4.
Create the BGP L2VPN
address family and enter BGP
Command
connection connection-name
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class class-name
| tunnel-policy
tunnel-policy-name ] *
bandwidth bandwidth-value
"Configuring
LDP."
Command
system-view
xconnect-group group-name
connection connection-name
peer ip-address pw-id pw-id
[ pw-class class-name |
tunnel-policy
tunnel-policy-name ] *
bandwidth bandwidth-value
Command
system-view
bgp as-number
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family l2vpn
416
Remarks
N/A
By default, no static PW is
configured.
By default, the expected value is
10000000 kbps.
Remarks
N/A
N/A
N/A
By default, no LDP PW is
configured.
After an LDP PW is created, the
PE automatically sends a targeted
hello to create an LDP session to
the peer PE. Then, the PE
exchanges the PW ID FEC and
PW label mapping with the peer.
By default, the expected
bandwidth is 10000000 kbps.
Remarks
N/A
By default, BGP is disabled.
By default, no BGP peer is
configured.
By default, the BGP L2VPN
address family is not created.
Advertisement
Table of Contents
