HP HPE FlexNetwork MSR Router Series Configuration Manual page 67

[RouterB] interface serial 2/1/0
[RouterB-Serial2/1/0] ospfv3 1 area 0.0.0.0
[RouterB-Serial2/1/0] quit
[RouterB] interface serial 2/1/1
[RouterB-Serial2/1/1] ospfv3 1 area 0.0.0.0
[RouterB-Serial2/1/1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] ospfv3
[RouterC-ospfv3-1] router-id 3.3.3.9
[RouterC-ospfv3-1] area 0
[RouterC-ospfv3-1-area-0.0.0.0] quit
[RouterC-ospfv3-1] quit
[RouterC] interface loopback 0
[RouterC-LoopBack0] ospfv3 1 area 0.0.0.0
[RouterC-LoopBack0] quit
[RouterC] interface gigabitethernet 2/0/1
[RouterC-GigabitEthernet2/0/1] ospfv3 1 area 0.0.0.0
[RouterC-GigabitEthernet2/0/1] quit
[RouterC] interface serial 2/1/0
[RouterC-Serial2/1/0] ospfv3 1 area 0.0.0.0
[RouterC-Serial2/1/0] quit
# Verify that the routers have learned the routes to each other. This example uses Router A.
[RouterA] display ipv6 routing-table
Destinations : 12
Destination: ::1/128
NextHop : ::1
Interface : InLoop0
Destination: 10::/64
NextHop : ::
Interface : Ser2/1/0
Destination: 10::1/128
NextHop : ::1
Interface : InLoop0
Destination: 11::/64
NextHop : ::
Interface : GE2/0/1
Destination: 11::1/128
NextHop : ::1
Interface : InLoop0
Destination: 20::/64
Routes : 12
57
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : O_INTRA