Configuring Ip Interworking Over An Ldp Pw - HP HPE FlexNetwork MSR Router Series Configuration Manual

Configuring IP interworking over an LDP PW

Network requirements
CE 1 and PE 1 are connected through Ethernet interfaces. CE 2 and PE 2 are connected through
serial interfaces, and they use PPP as the link layer protocol.
Configure an LDP PW between PE 1 and PE 2 and enable interworking on PEs to allow
communication between CE 1 and CE 2.
Figure 112 Network diagram
Table 41 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/0/1
[CE1-GigabitEthernet2/0/1] ip address 100.1.1.1 24
[CE1-GigabitEthernet2/0/1] quit
2. Configure PE 1:
# Configure an LSR ID.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
[PE1] l2vpn enable
Interface IP address
GE2/0/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE2/0/1 -
GE2/0/2 10.1.1.1/24
Ser2/1/0 100.1.1.2/24
Device Interface
P Loop0
GE2/0/1
GE2/0/2
PE 2 Loop0
Ser2/1/0
GE2/0/1
433
IP address
192.4.4.4/32
10.1.1.2/24
10.2.2.2/24
192.3.3.3/32
-
10.2.2.1/24