Configuring Ipv6 Mce - HP HPE FlexNetwork MSR Router Series Configuration Manual

Source
Destination : 5::5
Interface ID: 2147483649
Neighbor ID : 120.1.1.1, Neighbor state: Full
Cost: 1 State: P-2-P
Timers: Hello 10, Dead 40, Retransmit 5, Transmit delay 1
Request list: 0

Configuring IPv6 MCE

Network requirements
As shown in
different VPNs and advertise the VPN routes to PE 1 through OSPFv3.
Figure 97 Network diagram
VPN 1
2012:1::/64
2012:1::2/64
Configuration procedure
Assume that the system name of the MCE device is MCE, the system names of the edge routers of
VPN 1 and VPN 2 are VR1 and VR2, and the system name of PE 1 is PE1.
1. Configure VPN instances on the MCE and PE 1:
# On MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for
each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
: 3::3
Type: Sham
Retransmit list: 0
Figure 97, VPN 2 runs RIPng. Configure the MCE device to separate routes from
GE2/0/3.1
2001:2::3/64
GE2/0/2
2001:1::2/64
GE2/0/1
GE2/0/1
2001:1::1/64
VR 1
2002:1::2/64
2012::2/64
Instance ID: 0
PE 1
GE2/0/1.1
2001:2::4/64
GE2/0/1.2
2002:2::4/64
MCE
GE2/0/3.2
2002:2::3/64
GE2/0/2
2002:1::1/64
GE2/0/2
VR 2
GE2/0/1
VPN 2
2012::/64
391
VPN 2
Site 1
CE
PE 2
PE 3
CE
VPN 1
Site 2