Setup Instructions - Panasonic Future Electronics BULLSEYE Quick Start Manual

4. SETUP Instructions

4.1. Bullseye Board Setup
•
Verify Jumper on is present on P8 (to power the Inductive position sensor circuitry) (Fig.1)
•
Break-off the small Actuator PCB attached to the lower left corner of the Bullseye board, by twisting
up/down with your hand or using cutters. (Fig.2)
 Place this small actuator board anywhere in between the two guiderails (J11) & (J12), as shown in
Fig 2.
Fig.1 P8 Jumper
•
Connect the "Flex PCB" antenna (TE# 2108792-1, Fig.3) to connector (J3)
•
Connect the "Paddle" antenna (TE# 2195736-1 & 2016693-2, Fig.4) to connector (J4)
Fig.3 Flex PCB Antenna Connect to (J3)
- Industrial Wireless IoT solution
2108792-1
Page 3 of 11
www.FutureElectronics.com
Fig.2 Break Out Actuator Board
2016693-2
Fig.4 Paddle Antenna Connect to (J4)
Quick Start Guide
2195736-1