Quick Start | Conducting a measurement
9.2.3
Measuring with a VED sensor
Sec. 9.2.1:
Preparing a mea-
surement
For measuring edges and contours with the QUADRA-CHEK 3000 VED software
option, various measuring tools are available for the acquisition of measuring
points in the live image.
Further information:
The measurements illustrated here are described in detail in the
Measurement chapter.
For the measurements described in this section, a virtual camera
(Virtual Camera (GigE)) will be used with the representation of the
supplied 2-D demo part.
Application-specific adaptations during commissioning or setup can lead
to differing representations.
OEM or Setup users can switch to the virtual camera at any time in
order to try out the examples shown.
Further information:
option", page 65
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Sec. 9.2.2:
Sec. 9.2.3:
Measuring without
Measuring with a
a sensor
VED sensor
"Measuring tools", page 84
"Measure menu with QUADRA-CHEK 3000 VED software
Sec. 9.2.4:
Evaluating and
documenting the
measurement
9
169