HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 347

Settings | Service
Restoring the configuration
Backed-up configurations can be restored to the product. The current configuration
of the product is replaced in the process.
Software options that were active when the configuration was backed
up must be activated before restoring the configuration.
A restore can be necessary in the following cases:
During commissioning, the configuration data are set on a product and
transferred to all identical products
Further information:
After a reset to the factory default settings, the configuration data are copied
back to the product
Further information:
Performing a complete restore
Safely removing a USB mass storage device
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
"Commissioning steps", page 107
"Resetting to the factory defaults", page 350
Tap Settings in the main menu
Open in the sequence
Service
Backup and restore configuration
Restore configuration
Tap Complete restoration
If required, connect a USB mass storage device to a USB
port of the product
Navigate to the folder containing the configuration data
Select the configuration data
Tap OK
Confirm successful transfer with OK
The system is shut down
To restart the product with the transferred configuration data,
switch the product off and then back on
Tap File management in the main menu
Navigate to the list of storage locations
Tap Safely remove
Disconnect the USB mass storage device
15
347