Measuring With A Touch Probe - HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual

Measuring | Conducting a measurement
9.2.4

Measuring with a touch probe

The touch probe was configured
Prerequisite:
Further information:
Figure 26: Measure menu with touch probe
1 Current axis position
2 Last measured value, captured upon deflection of the stylus
Further information:
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
"Configuring a touch probe", Page 100
1
Tap Measure in the main menu
Select a preset where necessary
Approach the desired position
The display of the position is updated when the stylus
deflects
You can send the measured values to a computer
"Sending measured values to a computer", Page 145
2
9
143