Configuring Ved Sensors - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

7
Editing the existing Table of supporting points
Once the supporting point table for linear or segmented linear error compensation
has been created, it can be edited as needed.
7.3.3

Configuring VED sensors

Sec. 7 .3.1:
Basic settings
If the QUADRA-CHEK 3000 VED software option is active, the VED sensor must
be configured. This section describes the configuration procedure.
Setting the camera
118
Tap Settings in the main menu
Tap Axes
Select the axis
Open in the sequence
Error compensation
Segmented linear error compensation (SLEC)
Deactivate Compensation with the ON/OFF sliding switch
Tap Table of supporting points
The table lists the supporting point positions (P) and the
compensation values (D) of the individual segments
Adjust the compensation value (D) for the supporting points
Confirm the entries with RET
To switch to Segmented linear error compensation (SLEC),
tap Table of supporting points
Activate Compensation with the ON/OFF sliding switch
The adjusted linear error compensation for the axis is applied
Further information:
(SLEC)", page 343
Sec. 7 .3.2:
Configuring the axes
The product supports the use of a connected camera. Connecting more
than one camera can lead to faulty settings and incorrect measurement
results.
If no camera is detected, the product will switch to the virtual camera.
In this case, the live image will show the 2-D demo part.
Commissioning | Commissioning steps
"Segmented linear error compensation
Sec. 7.3.3:
Configuring VED sensors
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016