HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 262

11
Setting form tolerances
You can define the form tolerances for the following geometry parameters of a
feature:
Roundness for circles and arcs
Straightness for lines
262
The procedure for setting the form tolerances is the same for all
features. The following description shows how to perform roundness
tolerancing for a circle.
Drag the feature from the feature list into the workspace
The Overview tab is displayed
Tap the Tolerances tab
The tab for tolerancing the selected feature is displayed
Tap Roundness
An overview of the selected form tolerance appears
Activate tolerancing of the measured value with the ON/OFF
sliding switch
The drop-down list with the selected General tolerance ISO
2768 or Decimal place tolerances is activated
Measurement evaluation | Defining tolerances
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016