HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 167

Quick Start | Conducting a measurement
Measuring a slot
A minimum of five measuring points is required to measure a slot. Place at least
two measuring points on the first long side, one measuring point on the second
long side, and one measuring point on each arc of the slot. You can capture the
points in any sequence.
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Select Slot in the geometry palette
Position the first measuring point on the contour of the slot
Tap Enter in the Inspector
A new feature is displayed in the feature list of the Inspector
Position the second measuring point on the contour of the
slot
Distribute the measuring points along the entire
length of the first side, as far as possible.
Tap Enter in the Inspector
Repeat the last two steps for each of the remaining contour
points
Tap Finish in the new feature
The product calculates a new feature from the captured
measuring points and the selected geometry
The measured slot is displayed in the features preview
The measurement is complete
9
167