HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 174

9
Measuring the features
To measure features, you can use the geometries of the geometry palette or
Measure Magic. Measure Magic is able to automatically recognize the geometry
to be measured.
Further information:
This section provides examples describing how to measure three different
features:
1 Circle
2 Slot
3 Blob
Measuring a circle
A minimum of three measuring points is required to measure a circle. To capture
the measuring points, you can use e.g. the Circle measuring tool. Multiple
measuring points are automatically distributed along the entire contour according
to the specified settings.
174
"Overview of geometry types", page 191
Tap Measure in the main menu
Select Manual measuring in the function palette
If more than one optical sensor is active, select VED sensor
in the sensor palette
The geometry palette and the VED measuring tools are
displayed
Tap Live image preview in the Inspector
The workspace shows the camera's live image
In the quick access menu, select the magnification that is set
on the measuring machine
Select Circle in the geometry palette
Position the measured object in the live image by moving the
measuring plate
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016