HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 260

11
Setting General tolerance Decimal place tolerances
260
The nominal and actual dimensions are displayed
Tap the Nominal dimension input field to enter the nominal
dimension
Enter the desired value
Confirm entry with RET
Use the slider below Nominal dimension to set the tolerance
limit (number of decimal places)
The upper and lower tolerance limit values or the upper limit
and lower limit are displayed
The tolerance limits are entered automatically
based on the nominal dimension and the
specified general tolerance.
To switch between the Upper tolerance and Upper limit
input fields, tap Upper tolerance or Upper limit
The nominal value is shown in red if it is out of tolerance
The nominal value is shown in green if it is within tolerance
Tap the size tolerance
The Tolerances tab is displayed
The result of the tolerance test is displayed on the tab and in
the feature list
Measurement evaluation | Defining tolerances
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016