HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 340

15
Nonlinear error compensation (NLEC)
Parameter
Compensation
Number of supporting points
Spacing of the supporting points
Read deviations of calibration
standard
Table of supporting points
Teach sequence
Squareness error compensation (SEC)
Parameter
XY plane
XZ Plane
YZ plane
340
Explanation
Mechanical influences on the axes of the machine are compen-
sated
Settings:
ON: Compensation is active
OFF: Compensation is not active
Default value: OFF
Number of measuring points for error compensation on both
axes (X and Y) of the encoder
Setting range: 1 ... 99 (X and Y)
Default value: 2 (X and Y)
Spacing of the compensation points on the axes (X and Y)
Setting range: 0.00001 mm ... 100.0 mm (X and Y)
Default value: 0.00001 mm (X and Y)
The file containing the deviations of the calibration standard is
read
The overview of the table of supporting points is opened for
manual editing
The teach sequence for determining the compensation values is
started
Explanation
Mechanical influences on the squareness of the axes relative to
each other are compensated
Setting range: 85° ... 95°
Default value: 90
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Settings | Axes