HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 176

9
176
Select the edge detection mode at the bottom of the
workspace
Tap Enter in the Inspector
A new feature is displayed in the feature list
Position the measuring tool on the contour of the slot to
capture the second measuring point
Distribute the measuring points along the entire
length of the first side, as far as possible.
Tap Enter
Repeat the last two steps for the remaining three contour
points
Tap Finish in the new feature
The product calculates a new feature from the captured
measuring points and the selected geometry
The measured slot is displayed in the features preview
The measurement is complete
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016