HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 179

Quick Start | Conducting a measurement
The Overview shows the following details about the feature:
Name of the feature
Axis positions of the center point
Feature parameters, depending on the type of geometry
Number of measuring points used for calculating the feature
Fitting algorithm used for calculating the feature (depending on the geometry
and the number of measuring points)
List of geometry types to which the feature can be converted
Renaming a feature
Adjusting the fitting algorithm
You can adjust the fitting algorithm depending on the measured feature. The
geometry is basically calculated using the Gaussian fitting algorithm.
Further information:
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Drag the feature from the feature list into the workspace
The Details dialog appears with the Overview tab selected
Tap the input field containing the current name
Enter a name for the feature
Confirm entry with RET
The new name is displayed in the feature list
Tap Close to close the dialog
"Fitting algorithm", page 248
Drag the feature from the feature list into the workspace
The Details dialog appears with the Overview tab selected
The fitting algorithm used is displayed
Select the desired fitting algorithm in the Fitting algorithm
drop-down list
The feature is displayed according to the selected fitting
algorithm
Further information: "Display of measuring points and form",
page 247
Tap Close to close the dialog
9
179