HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 79

Basic operation | Using the Inspector
Operating
element
...
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Short description
Program step list
The program step list shows all actions that occur during
the measurement. It is displayed instead of the feature list
in the Inspector.
The program steps can be combined and saved as
measuring programs.
Further information: "Programming", page 271
Miscellaneous functions
The miscellaneous functions comprise the following
functions:
Switching the display between feature list and program
step list
Creating and saving a program
Calling the program control in the workspace
Deleting selected features or all features from the
feature list
Enter
If automatic measuring point acquisition is deactivated, the
measuring points are acquired manually.
If automatic measuring point acquisition is active, a red dot
is shown in the operating element.
If automatic measuring point acquisition is active, the
measuring points are acquired after the set timeout
expires.
6
79