HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 142

8
Configuring the network
For the network setting details, contact your network administrator.
Further information:
142
The configuration of the network settings is the same for all network
connections.
Tap Settings in the main menu
Tap Interfaces
Tap Network
Tap the desired interface (X116 or X117)
The MAC address is detected automatically
Depending on the network environment, activate or
deactivate DHCP with the ON/OFF sliding switch
If DHCP is active, the network settings are obtained
automatically as soon as the IP address is assigned
If the DHCP protocol is not active, enter the IPv4 address,
IPv4 subnet mask and IPv4 standard gateway
Confirm the entries with RET
Depending on the network environment, activate or
deactivate IPv6 SLAAC with the ON/OFF sliding switch
If IPv6 SLAAC is active, the network settings are obtained
automatically as soon as the IP address is assigned
If IPv6 SLAAC is not active, enter the IPv6 address, IPv6
subnet prefix length and IPv6 standard gateway
Confirm the entries with RET
Enter the Preferred DNS server and, if required, the
Alternative DNS server
Confirm the entries with RET
The configuration of the network connection is applied
"Network", page 333
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Setup | Setup steps