Mounting | Assembly of the device
4.2.2
Mounting on Multi-Pos stand
Use the four supplied M4 x 8 ISO 14581 (black) countersunk screws for
attachment to the threaded holes on the rear panel. The permissible tightening
torque is 2.5 Nm.
Using two M5 screws, you can screw the stand to a supporting surface from the
bottom.
You can tilt the stand to any angle within the 90° tilt range. The recommended
tightening torque for the T25 screw is 5.0 Nm. The maximum permissible
tightening torque for the T25 screw is 15.0 Nm.
The cables are routed together through the opening in the stand from behind and
then laterally below the joint to the connections.
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
4
33