HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 297

Measurement report | Creating and editing a template
Adding or removing form fields
The form fields listed below can be inserted into the report header of the
measurement report. During the creation of the measurement report, the form
fields are filled according to the entries made.
Form field
Timestamp
Job
User name
Part number
Fixed text
Variable text
Logo
Omitted features
Failed tolerances
Product designation
Serial number
Firmware version
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
To add or remove a form field, tap the form field in the list
Active form fields are indicated by a check mark
The form field is inserted into the template or removed from
the template
Meaning and application
The date and time are inserted.
The job is inserted.
The user name is inserted.
The part number is inserted.
Fixed text is inserted into the template.
Tap the Fixed text form field in the template
An input field opens
Enter text
To close the input field, tap anywhere outside
the input field
Variable text is inserted. You can type the variable
text into the template. When creating the
measurement report, you can overwrite the text as
needed.
A logo is inserted.
Tap the Logo form field in the template
A dialog appears
Select the desired logo in the storage location
Tap OK to close the dialog
The logo is inserted into the template
The number of measured features that are not
displayed in the measurement report is inserted.
The number of features that are out of tolerance is
inserted.
The product designation of the product is inserted.
The serial number of the product is inserted.
The firmware version currently installed on the
product is inserted.
13
297