HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 257

Measurement evaluation | Defining tolerances
Selecting general tolerances
The tolerance tables defined in the ISO 2768 standard are stored on the product
for all tolerance classes.
Defining the decimal place tolerance
You can define a separate tolerance for each decimal place.
Deactivating general tolerances
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Tap the checkbox next to General tolerance to activate the
general tolerances
The active checkbox is highlighted in green
Select the desired standard in the Standard drop-down list
Select the desired tolerance class in the Length, angle,
rounding arc and chamfers drop-down list
Select the desired tolerance class in the Straightness,
symmetry, runout, flatness and perpendicularity drop-
down list
Tap General tolerances
The selected general tolerance is displayed on the
Tolerances tab
To perform decimal place tolerancing, tap the checkbox next
to Decimal place tolerances
The active checkbox is highlighted in green
Tap an input field
Enter a value for the tolerance limit
Confirm entry with RET
Repeat the last three steps for the remaining decimal places
Tap General tolerances
The Decimal place tolerances are displayed on the
Tolerances tab
Tap the checkbox next to No general tolerances to
deactivate the general tolerances
The active checkbox is highlighted in green
Tap General tolerances
No general tolerance is displayed on the Tolerances tab
11
257