HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 198

10
Capturing measuring points with the 'Crosshair' VED measuring tool
198
Tap Measure in the main menu
Select Manual measuring in the function palette
Select Circle in the geometry palette
Position the measured object in the live image by moving the
measuring plate
Select Crosshair in the tool palette
Position the measuring tool in the live image by tapping or
dragging
If automatic measuring point acquisition is active, the
measuring point is captured automatically
Further information: "Setting automatic measuring point
acquisition", page 81
If automatic measuring point acquisition is not active, tap
Enter in the Inspector
A new feature appears in the feature list of the Inspector. The
symbol of the feature corresponds to the selected geometry
The number of captured measuring points is shown next to
the symbol
Position the second measuring point on the contour of the
slot
Distribute the measuring points as evenly as
possible along the contour of the feature.
Tap Enter in the Inspector
Repeat the last two steps for the third measuring point
As soon as a sufficient number of measuring points have
been captured for the feature, a check mark appears next to
the feature in the feature list
Measurement | Capturing measuring points
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016