Mounting On Duo-Pos Stand - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

Mounting | Assembly of the device
4.2.1

Mounting on Duo-Pos stand

You can attach the Duo-Pos stand to the product at a 20° or 45° angle.
Use the two supplied M4 x 8 ISO 7380 hexagon socket screws to attach the stand
to the lower threaded holes on the rear panel. The permissible tightening torque is
2.5 Nm.
Using the mounting slots (width = 4.5 mm), you can screw the stand to a
supporting surface.
The cables are routed together through the two supports of the stand from behind
and then through the lateral openings to the connections.
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
4
31