Overview; Conducting A Measurement - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

9
9.1

Overview

The Quick Start chapter describes the steps of a general measuring sequence
on the product. The steps range e.g. from aligning the measured object and
measuring the features through to creating the measurement report. For a detailed
description of the individual activities, please refer to the
and subsequent chapters.
Depending on the configuration of the product and the enabled software options,
you can capture measuring points without or with a sensor. The product identifies
the captured measuring points as features and displays them.
Requirement:
9.2

Conducting a measurement

This section describes the typical steps for conducting a measurement. The
description provides an overview and, thus, additional steps may be necessary
depending on the measuring machine or the respective measuring application.
Sec. 9.2.1:
Preparing a measure-
ment
Preparing the
measured object
and measuring
machine
Conducting the
reference mark
search
Adjusting the
sensors
158
Commissioning and setup have been completed.
Sec. 9.2.2:
Measuring without a
sensor
Aligning the
measured object
Measuring the
features
Measurement chapter
Sec. 9.2.3:
Measuring with a VED
sensor
Aligning the
measured object
Measuring the
features
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Quick Start | Overview
Sec. 9.2.4:
Evaluating and docu-
menting the measure-
ment
Displaying and
editing the
measurement
results
Outputting
measurement
reports
Using measuring
programs