Adjusting The Lighting - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

6
6.7

Adjusting the lighting

You can connect two different light sources and one laser pointer to the product
and adjust them separately.
Transmitted light: Light source below the measured object (backlight)
Reflected light: Light source with four segments that can be switched indi-
vidually
Laser pointer: Point light above the measured object that can be used as a
positioning aid
Displaying the lighting palette
1
1 Slider for transmitted light
2 Preset operating elements
3 Segment switch for reflected light
4 Laser pointer
5 Slider for the reflected-light segments
94
The lighting palette is only available if an optical sensor is active. The
selection and the range of functions depend on the device settings and
the connected light unit.
Tap Measure in the main menu
The user interface for measuring, constructing and defining is
displayed
Select Manual measuring
If required, tap Live image preview in the Inspector
The live image is shown in the workspace
Tap Lighting palette
The operating elements of the lighting palette are displayed
Set the lighting according to the properties of the measured object.
Basic operation | Adjusting the lighting
2 3 4
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
5