Installing The Media Modules; Before Inserting Media Modules Into The Branch Gateway Or Em200 Chassis - Avaya G430 Installation And Upgrades

Installing the Branch Gateway and EM200
2. Connect the other end of the expansion cable to the CONNECTOR IN connector on the
rear of the EM200.
Figure 2: Connecting an EM200 to the G430
• If you mounted two EM200 modules, connect one EM200 to the CONNECTOR OUT 1
connector on the rear of the G430, and one EM200 to the CONNECTOR OUT 2 connector on
the rear of the G430.
Related links
Mounting the EM200 expansion module(s)

Installing the media modules

When the Branch Gateway chassis and optionally the EM200 module(s) are installed, you can insert
the media modules. Each module is shipped with two thumb screws for securing the module in the
Branch Gateway or EM200 chassis.
Note:
The required media modules are sometimes pre-installed in the Branch Gateway or EM200
chassis. If this is the case, skip this step. Read this section only if the media modules are not
pre-installed, or if you want to replace modules or add new media modules.
Related links

Before inserting media modules into the Branch Gateway or EM200 chassis

Combination limitations
Slot allocation on page 29
Inserting the S8300 Server
Inserting media modules
Before inserting media modules into the Branch Gateway or
EM200 chassis
• Do not install an unsupported combination of media modules. See
page 29.
• Allocate a permissible slot to each media module. See
February 2017
on page 27
on page 29
on page 31
on page 32
Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
on page 28
Combination limitations
Allocating slots on page 29.
on
28