External Diversion (As Of Sw 2.0.1+); Call Forwarding In The Case Of External Diversion (As Of Sw Version 2.0.2) - Siemens Hicom 100 E Service Manual

10.7.5

External diversion (as of SW 2.0.1+)

In the case of call diversion to an external destination, the caller is not connected to the call
diversion destination extension until the call has been answered. It is possible to configure the
system so that the caller is immediately connected to the outgoing external line.
Example: changing to immediate connection in the case of external call diversion.
Input sequence
A 2 1 4 (up to SW 2.0.1+)
2 1 4 1 (as of SW 2.1)
B *
C 1
D <OK>
<F8>
E
"Connection: when call is answered" can be set by entering "0" under point C.
10.7.6 Call forwarding in the case of external diversion (as of SW
version 2.0.2)
If external call diversion has been activated for an extension, an incoming call is no longer
forwarded to the subsequent internal call forwarding destinations. The call remains at the
external call diversion destination.
You must activate the appropriate mode if you wish to forward a call received by the external
call diversion destination.
Example: call forwarding is to be activated.
Input sequence
A 2 1 4 1
B *
C 1
D <OK>
<F8>
E
The "disabled" mode can be reset by entering "0" under point C.
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
Meaning
Connection with call diversion,
external
Change input
Select immediate connection
Confirm input
Return to Start menu
Meaning
Call forwarding mode
Change input
Select enable
Confirm input
Return to Start menu
Programming guide
System settings
Display
Connection: when call is
answered
Connection:
Connection: immediate
Connection: immediate
System administration
Display
Mode: disabled
Mode:
Mode: enabled
Mode: enabled
System administration
10-61