Siemens Hicom 100 E Service Manual page 212

The port only uses DTMF dialling if the station type is set to "answering machine"–
required for announcement equipment, e.g. "Genius".
10.4.1.3 Stations connected to the S
At least one free ISDN port (module STLS 2 or 4) is necessary to connect an internal ISDN
extension. A maximum of 8 ISDN extensions (stations) can be connected to an internal S
(see installation instructions "S
for each of these 8 possible extensions (input sequence see "Stations at the a/b port" Section
10.4.1.2)
The required extension number is to be programmed on the ISDN terminal as its own MSN and
is accepted by Hicom 100E. Collisions with other Hicom 100E internal extension numbers are
to be avoided when selecting the extension number! The ISDN port in question is to be
programmed as a "Euro bus".
Example: ISDN port 4 is to become an internal S
Input sequence
A 1 9 3
B +
C +
D +
E *
F 4
G <OK>
H <F8>
As of SW 2.0.2, the "Default" display will be replaced by "Automatic".
A supplementary PSU is required for an ISDN telephone.
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
bus
0
ext." in the Service Manual). The station type is programmable
0
Meaning
Port configuration of port 1
(select port 1 to 16 with "+" and "–" or
directly with "#")
Port configuration of port 2
Port configuration of port 3
Port configuration of port 4
Change input
Euro bus
Confirm input
Return to Start menu
bus, Section 10.1.1.2
0
Port 1: automatic
Port 2: automatic
Port 3: automatic
Port 4 automatic
Port 4:
Port 4: Euro bus
Port 4: Euro bus
System administration
Programming guide
Programming extensions
Display
10-17
bus
0