Connection As Slave; Automatic Line Seizure (Simplified Dialling) - Siemens Hicom 100 E Service Manual

Programming guide
Networking
10.3.3.2

Connection as slave

In this type of network, at least one TLA 2 or TLA 4 module is required in the Hicom 100E
system. At least one trunk interface is to be connected to an analogue extension interface
(DTMF flash necessary) of the main PBX.
The route in which the lines to the main PBX are located is to be programmed as a "PBX".
Example: the line to the main PBX is located in route 2
For the input sequence for the route assignment, see Section 10.3.5
Route 2 is programmed as a PBX.
Input sequence
A 1 6 4 (up to
SW2.0.2)
1 6 14(as of SW2.1)
B +
C *
D 1
D <OK>
E <F8>
The line type of a route can be reprogrammed as a "trunk" by entering "0" under point D.
10.3.4

Automatic line seizure (Simplified dialling)

The line is seized automatically when an outgoing external call is set up from an "optiset..."
system telephone. All lines are therefore located in one and the same route.
Automatic line seizure must be deactivated if lines are to be distributed to two or more different
routes. In this case, it is necessary to prefix the number with the appropriate route code in order
to set up an external call.
Input sequence
A 1 6 1 (up to
SW2.0.2)
1 6 11(as of SW2.1)
B *
C 0
D <OK>
E <F8>
Deactivated automatic line seizure can be reactivated by entering "1" under point C.
10-10
Meaning
Line type route 1
(select route 1–4 with "+" and "–" or
directly with "#")
Line type route 2
Change input
PBX type
Confirm input
Return to Start menu
Meaning
Simplified dialling
Change input
Simplified dialling OFF
Confirm input
Return to Start menu
Display
Route 1: trunk
Route 2: trunk
Route 2:
Route 2: PBX
Route 2: PBX
System administration
Display
Status: on
Status:
Status: on
Status: on
System administration
A31003-K16-X001-3-7620
Hicom 100 E Version 2.1, Service manual
,
07/99