Table of Contents
Advertisement
Command
Description
LHO+STOP
Stops the motor.
LHO LHO+MOVR
Moves the motor a given number of steps based on the
<step>
current location.
Examples
Return current motor position along the horizontal axis and direction:
(LHO?)
Move lens to position 500 along the horizontal axis with a positive approach:
(LHO 500 1)
Move lens to position 500 along the horizontal axis with a negative approach:
(LHO 500 -1)
Move the motor 100 steps in a negative direction:
(LHO+MOVR -100)
Move the motor 200 steps in a positive direction:
(LHO+MOVR 200)
Stop the motor:
(LHO+STOP)
Start the motor moving in a positive direction:
(LHO+STRT 1)
LPF–Lamp File
Gets or sets the lamp file for the active or specified channel.
Parameters
•
Access level: Installer
•
Power level (minimum): Power Up
Commands
Command
LPF?
LPF?L
LPF "<lamp file>"
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Returns the lamp file in use by the active
channel. (Read-only)
Returns a list of all available lamp files.
(Read-only)
Sets the lamp file for the active channel.
™
CineLife+
serial commands
Values
—
step = Numeric value
Values
—
—
lamp file = Subject to the range
returned in LPF? or LPF?L
17
Advertisement
Table of Contents
