Setting Up The Chiller Unit; Connecting The Chiller Communication Cable - Christie CP4440-RGB Installation And Setup Manual

Installing and setting up
Mode Description
• IMB is on.

Setting up the chiller unit

For detailed information on setting up the chiller, refer to the documentation provided by the
manufacturer of the chiller unit.
Once the chiller is connected to AC and the chiller communication cable is connected to the projector,
the projector controls the chiller automatically to maintain the required coolant temperature.

Connecting the chiller communication cable

The chiller communication cable is connected through a signal terminal located at the front of the
chiller unit. The connection allows communication between the projector and the chiller.
The chiller communication cable includes an RS-485 connector, attached cable with rubber grommet,
and three terminal connectors.
The installation of the chiller communication cable must be performed by a Christie qualified technician.
1. Remove the cover for the signal terminal by unscrewing the two cover screws.
CP4440-RGB and CP4450-RGB Installation and Setup Guide 35
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.