Lamp States; Turning The Projector Off - Christie Boxer 4K30 User Manual

LED State
Solid magenta Shutter closed
Off Shutter open

Lamp states

LED State
Off
On
Warming up
Cooling down
Hours exceed user limit
Failed to strike
Lamp off - Unknown
Lamp off - Interlock
Missing

Turning the projector off

1. To turn the lamps off, press and hold the Power button until you hear a beep.
It takes approximately one minute to power down the lamps. When powering off the projector,
allow the projector to complete its cool down cycle. Do not immediately unplug the projector if
this can be avoided.
2. To turn off power to the projector, disconnect from AC power.
Boxer 4K30 User Manual
020-101777-01 Rev. 1 (03-2015)
Description
The shutter is closed.
In standby, the shutter is always automatically closed and the
magenta light is muted.
The shutter is open.
Description
Lamp is off.
Lamp is on.
Lamp is warming up
Lamp is cooling down.
Displayed if the user set a warning level and the hours exceed it.
Lamp failed to strike.
Lamp is off but the state is unknown because the lamp driver could
not be communicated with.
Lamp is off due to an interlock being triggered.
Lamp is not installed.
Introduction
16