Connecting The Fiber Optic Cable To The Projector Through The Curved Strain Relief - Christie Mirage SST Installation And Setup Manual

A Fiber connector
B Dust cap
8. Close the safety cover lid and tighten the screw.
The tethered safety cover must remain installed on the fiber connector whenever the fiber
optic cable is not connected to the projector.
When the fiber optic cable is connected to the projector, store the fiber connector dust cap
inside the tethered safety cover.
Connecting the fiber optic cable to the projector through the
curved strain relief
Attach the fiber optic cables from the laser illumination source to the projector using a curved strain
relief.
For additional information on the laser illumination source and the fiber optic cable, refer to the laser
illumination source's product documentation.
1. On the rear of the projector, loosen the screw securing the laser safety bracket.
2. Remove the fiber connector safety cover.
3. Remove the dust cover from the fiber input location and ensure the knurled ring and locking
pin are both rotated counterclockwise.
4. To remove the top clamp from the bottom of the strain relief, remove the four screws.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
33