Table of Contents
Advertisement
Step 3
Set up the multi-overlap settings for showing the keypad.
*1
Overlap ID
Overlap Library No.
Display Position
*1 With [
With Entry Key] checked, if any overlap display other than the multi-overlap
display has been registered, the following message is displayed.
Select another ID.
If another multi-overlap display is already registered at the same overlap ID, no error
occurs.
However, when the keypad is displayed on the MONITOUCH, the multi-overlap
display that is previously displayed will disappear.
*2 Unless you press the [Register] button, the keypad will not be registered in the
overlap library.
Step 4
When the setup has been completed, an overlap icon (for multi-overlap) is displayed in
addition to the numerical data display on the screen.
Specify the overlap ID to be used for showing the
keypad.
Specify the overlap library number of the keypad.
*2
Press the [Register] button
keypad, and register it in the overlap library.
If it is already registered in the overlap library, simply
specify the number.
When this box is checked, the multi-overlap display
position can be set.
• [X Coordinate], [Y Coordinate]
Specify the coordinate values to set the display
position.
• [Specify with Mouse] button
When this button is clicked, a cross-shaped cursor
appears on the screen. Move the cursor to the
desired position and click the mouse to determine the
position.
6.1
Data Display
, select the desired
6-3
6
Advertisement
Table of Contents
