FE MONITOUCH V8 SERIES Reference: Additional Functions page 49

2 Global Overlap
Coordinate
Designation
[Detail] Tab Window
Command
Memory *
Item Select
Memory
* If you select [System Setting] → [Device Communication Setting] → [Read/Write Area] and
check [
becomes invalid.
2-4
This is valid only when [External] is selected for [Designate].
A memory address of [Info Output Memory] "n + 2" or "n + 3" is
automatically allocated.
Checked:
Specify the coordinate position where the overlap display is shown from
the memory.
[Info Output Memory] "n + 2": X coordinate
[Info Output Memory] "n + 3": Y coordinate
Unchecked:
The overlap display is shown in the same position as it is placed for the
overlap library.
Checked:
Specify one word of memory as desired.
This is used for showing or hiding the overlap display according to the
data in the specified memory address.
However, it is not possible to use bit 3 of read area "n + 1" for showing or
hiding the overlap display.
15 14 13
0 0 0
Unchecked:
Bit 3 of read area "n + 1" is used at all times.
This is required when using "entry mode" on the overlap screen.
For more information, refer to the V8 Series Reference Manual.
GD-80 Compatible Read/Write Area], the setting for [
12 11 10 09 08 07
0 0 0 0 0 0
Not used (Be sure to set "0".)
06 05 04 03 02 01
0 0 0 0 0 0
1: Show
0: Hide
Command Memory]
00