Table of Contents
Advertisement
1.1
Edit Model Selection
Portrait Orientation
The V806 series can be installed in portrait orientation.
Be sure that the power supply faces upward. In this position, the function switches on the V806 are
in a lower position.
V-SFT
When the box for [
portrait-orientated unit is possible.
For where the setting item is provided, refer to page 1-1.
Notes
• In a case where you attempt to convert landscape-orientated data in V-SFT to portrait-oriented
data (by automatic resizing), the following dialog appears.
You cannot undo the conversion.
• Automatic resizing is executable in the following areas:
Screen, screen library, overlap library, graphic library, and data block
• Character properties will be adjusted to a maximum extent, according to resizing.
However, such an adjustment to character properties is not available with the following functions:
bit order alarming, alarm sub-display, time order alarming, alarm logging, message mode, data
sampling, alarm tracking, and memory card
• For any parts which are not ready for automatic resizing, resize them by manual operation.
• Unchecking the box for [
Setting]) will help resize characters neatly.
• When specifying the coordinates (start X, start Y) of an overlap in dots, they are determined in
increments of one dot on the X axis and four dots on the Y axis. (For landscape orientation,
coordinates are determined in increments of four dots on the X axis and one dot on the Y axis.)
Therefore, when portrait orientation is adopted, a Y-axis coordinate will be rounded down to a
multiple of 4.
1-2
Front View
Portrait] is checked in the [Edit Model Selection] dialog, V-SFT editing that suits a
Place switches on switch grids] (in the V-SFT, [View] → [Grid] → [Grid
Rear View
Advertisement
Table of Contents
