FE MONITOUCH V8 SERIES Reference: Additional Functions page 244

Basic Authentication Setting
Basic authentication is provided to permit or prohibit access from anonymous users.
The use of basic authentication prohibits access from anonymous users.
1. Open the [Setup] window.
If basic authentication is not in use, pressing the [Setup] button calls up the dialog as shown in step
3 in "Access from the Computer" page 18-7. Enter the user name and the password as already
registered.
2. In the menu located to the left of the screen, click [Basic Configuration Instructions] → [Users].
3. If there is no check mark for the options under [User Settings], basic authentication is required for
the network camera.
2.
When selecting the use of basic authentication, make the following settings in the V-SFT software:
As shown below, check [
as already registered. To see the registered user name and the password, refer to "User Name and
Password Check and Registration" page 18-12.
4. If basic authentication is not necessary, check [
or password required)] for [User Settings] and click the [Save] button for confirmation.
* When operating the camera by the switch on the V8 series, check [
control login (no user name or password required)] and click the [Save] button for confirmation.
For more information, refer to "Camera Lens Operation from the V8 Series" (page 18-13).
3.
4.
Use basic authentication] and then enter the user ID and the password
Enable anonymous viewer login (no user name
18 Network Camera
1.
Enable anonymous PTZ
18-11
18